7.4.16. Agent mode commands

/AgentMode

Enable Designer Agent mode. If this command is present, /DisableStartupMessages /DisableStartupDialogs commands are ignored, if specified.

/AgentPort <Port>

Specifies a network port number to be used by Designer Agent in SSH server mode. If the command is not specified, Designer Agent uses a network port with number 1543 by default.

/AgentListenAddress <Address>

Command parameter allows you to specify the IP address which Designer Agent listens to. If the command is not specified, IP address 127.0.0.1 will be used by default.

/AgentSSHHostKey <private key>

Command parameter allows you to specify the path to the private host key. If the parameter is not specified, /AgentSSHHostKeyAuto command must be specified. If no command is specified, Designer cannot be started in agent mode.

/AgentSSHHostKeyAuto

The command specifies, the host private key is located in the directory below (depending on the operating system):

On Windows: %LOCALAPPDATA%\1C\1cv8\host_id.
On Linux: ~/.1cv8/1C/1cv8/host_id.
On macOS: ~/.1cv8/1C/1cv8/host_id.

If the specified file is not found, a new 2048-bit private RSA key is generated.

/AgentBaseDir <working directory>

This command allows you to specify the working directory, which is used for SFTP server and for configuration dump and restore commands.

If the command is not specified, the following directory is used:

On Windows: %LOCALAPPDATA%\1C\1cv8\<Infobase UUID>\sftp.
On Linux: ~/.1cv8/1C/1cv8/<Infobase UUID>/sftp.
On macOS: ~/.1cv8/1C/1cv8/<Infobase UUID>/sftp.